COVID-19: Signs, Symptoms, and Testing

Hi everyone, per request we’re going to be talking about what to look for with regards to COVID-19.

 

  • Signs and symptoms

    • The most common presenting symptom is fever, present in anywhere from 43% - 98% of patients depending on what study you look at.

      • No matter what study you choose though, fever is not present in 100% of infected patients, so the absence of a fever is not enough to rule out COVID-19 in a patient.

    • The next most common constellation of symptoms are lower respiratory, with the most common of those being cough

      • Cough is present in 68% - 82% of patients

      • Other lower respiratory symptoms you may see include dyspnea, chest tightness, sputum production, and hemoptysis

      • Some patients may develop “silent hypoxemia” in which they become hypoxic without feeling short of breath

    • Less commonly you may see upper respiratory symptoms in these patients, including rhinorrhea and sore throat (5-24% and 5-14% respectively)

    • The least common presenting symptom is GI symptoms

      • These include nausea and vomiting in 1-10% of cases and diarrhea in 2-8% of cases

      • While more rare than other presenting symptoms, up to 10% of patients may present with GI symptoms rather than fever or respiratory symptoms

      • It is important to consider COVID-19 in these patients as well

  • Physical exam is typically non-specific and not particularly helpful in distinguishing COVID-19 from other viral infections

  • Labs

    • WBC tends to be normal, but is often associated with lymphopenia, seen in approximately 80% of patients

    • Mild thrombocytopenia is also commonly seen

      • Lower platelet counts are associated with worse prognosis

    • Procalcitonin is not typically elevated with this infection

      • If there is an elevated procalcitonin, it is more likely not COVID-19 and other diagnoses should be pursued

    • Elevated CRP, however, is associated with COVID-19 and tracks with severity and prognosis

      • An elevated CRP in a patient with respiratory failure suggests that COVID-19 is less likely, and other diagnoses like CHF exacerbation may the cause

    • Positive testing for other viruses like those found on RVP or influenza don’t rule out a diagnosis of COVID-19, but do make it less likely

  • Imaging

    • Chest xray and CT chest

      • Typically shows patchy ground glass opacities 

        • More commonly peripheral and basal

        • Can be very subtle and easy to miss on xray

      • It is very rare to see pleural effusion (seen in 5% of cases)

      • Chest xray has a sensitivity of 59%

      • CT chest has a sensitivity of 86-97%

      • CT findings may be evident before the patient is symptomatic

    • Ultrasound

      • A lung ultrasound can also be used in the workup for COVID-19

      • To obtain higher sensitivity, you should perform a thorough lung ultrasound in order to visualize as much lung tissue as possible

        • A “lawnmower” approach can be utilized to achieve this

      • Depending on the severity of the disease, you may note different findings on ultrasound (obtained from https://emcrit.org/ibcc/covid19/#signs_and_symptoms):

        • (A) Least severe:  Mild ground-glass opacity on CT scan correlates to scattered B-lines.

        • (B) More confluent ground-glass opacity on CT scan correlates to coalescent B-lines (“waterfall sign”).

        • (C) With more severe disease, small peripheral consolidations are seen on CT scan and ultrasound.

        • (D) In the most severe form, the volume of consolidated lung increases.    

A good source you can use to obtain additional information is https://emcrit.org/ibcc/covid19/#lung_ultrasonography

 

Stay safe out there everyone!

COVID-19 ultrasound.png
 · 

Testing Process for COVID-19

COVID-19 testing

 

Hi everyone,

 

The process for testing for COVID-19 keeps changing and has become pretty confusing.  So we’re going to go through it all in detail!  If you have any questions about what needs to be done, you can also always call the lab at 718-283-8231 for more information.

 

  1. Call the DoH for approval to test for COVID-19

    • Their number is 866-692-3641

      • This number can also be found via the globe by scrolling to the bottom of the screen under the Phone Numbers section, or in the lab order screen after selecting COVID-19 Screening.

    • Be aware, they are currently only approving testing for patients being admitted to the hospital.  If you feel strongly that a patient who is being discharged should be tested, you will need to send the samples up to the lab which will store the samples until commercial testing becomes available.  This doesn’t mean don’t call the DoH, but just be prepared that they will probably deny the test for discharged patients.

  2. If they approve the testing, they will take down your information and provide you with a subject number.  You need this subject number in order for the lab to process the test and send it out to the DoH for testing.  You should ask them for the subject number over the phone, otherwise you may be waiting a long time for an email with that information.

  3. If they do not approve the testing but you feel that this patient should be tested, for example they are being discharged but you consider them high risk, then you will not be given a subject number by the DoH.  Simply place the order through HMED and the lab should hold onto the samples until a commercial testing site is available to run them.

  4. Whether the DoH approved the testing or not, order the COVID-19 testing through HMED.  It can be found under Common labs à COVID-19 Screening.

  5. Complete the COVID-19 Lab Submission Request

    • To do this, click on the globe and select “Taylor Healthcare (Standard Register)” under the Patient Specific Links section.

    • Once on Taylor Healthcare, search for “covid” or “10087” (the document number) to find the form

    • Print out the selected form and complete any sections marked with an *

  6. Collect the specimens.  This requires 1 nasopharyngeal swab and 1 oropharyngeal swab.

    • You should use the flu swabs, which are the same as the RVP swabs, for both samples.  These can be found with the charge nurse.    

    • For the nasopharyngeal swab, insert the swab in 1 nostril parallel to the palate.  Leave the swab there for a few seconds to absorb secretions, then remove.  Repeat this process in the other nostril using the same swab.

    • For the oropharyngeal swab, insert a new swab into the posterior oropharynx, avoiding the tongue.  This is similar to a strep swab.

    • Each swab should be in its own medium, do not combine them.  In other words, you should have 1 tube with 1 nasopharyngeal swab, and a 2nd tube with 1 oropharyngeal swab.

  7. Label the specimens with the following information:

    • Patient’s first and last names

    • Patient date of birth

    • Date and time of collection

    • Specimen source

  8. Make sure the subject number provided by the DoH (if they approved the test) is associated with these samples, either on the label itself or on the biohazard bag, as well as in a progress note in the chart

  9. Transport the specimen to the lab for testing.

    • All specimens must be transported by hand to the lab.

    • All specimens should be in a biohazard bag and transported in a Styrofoam container.

      •      You can get a Styrofoam container from the charge nurse.

    • Wear gloves while transporting the specimens!


Airway Management in a Coronavirus Patient

Today we’re going to forego trauma Tuesday to talk about everyone’s favorite topics nowadays: coronavirus and intubating!

  • Your patient has suspected or known COVID-19 and is starting to desaturate on room air.  Now what?

    • Just like any other patient, the first thing to try is oxygen, either via nasal cannula or NRB

    • You can crank up the nasal cannula as high as 6 in order to help maintain oxygenation

  • Great, but my patient is continuing to desaturate even with oxygen.

    • This is where things change from any other patient:

    • DO NOT USE BIPAP OR HIGH FLOW NC

      • When these patients get very ill, these modalities have a high likelihood of failing them

      • These 2 modalities also will result in significant aerosolized spread of covid-19

        • Even if you put them in a negative pressure isolation room with the bipap, you will have no way of transporting them

      • SO JUST DON’T DO IT

  • OK, so I can’t use bipap or HFNC but my patient is still desaturating…

    • It’s time to intubate!

    • You should intubate early with these patients, and avoid crash intubations whenever possible

    • Step 1: gown up

      • This means gown, gloves, N95, and a mask with face shield over your N95

    • Step 2: pre-oxygenate

      • Pre-oxygenate using NRB

      • You do not want to use apneic oxygenation via nasal cannula, as this will further aerosolize the virus and has marginal evidence supporting it even in the best conditions

      • Do not bag the patient if it can at all be avoided; again, this will aerosolize the virus and result in increased risk of exposure for everyone in the area

    • Step 3: intubate

      • Use VL instead of DL

        • VL allows you to stay farther away from the patients mouth and secretions, helping protect you against the virus

      • The most experienced person should be performing the intubation – you want to maximize the chances for first pass success

    • Step 4: set the vent (or have someone else do it if you’re gowned up)

      • Treat these patients as ARDS patients and use the ARDSnet protocol with low tidal volumes

      • Unlike ARDS, however, steroids do not play a role in management

    • Step 5: de-gown

      • Ideally, have a spotter present so they can help make sure you don’t accidentally contaminate yourself during this process

      • In particular, be careful not to contaminate any mucous membranes, meaning be particularly careful around your eyes, nose, and mouth

      • Wash your hands!

  • Congratulations! You have successfully intubated this patient without unnecessarily exposing yourself or your colleagues to coronavirus!